I bought this since I couldn't find my exact replacement for my Maytag washer and the part was on backorder for several weeks. I read some other reviews on other sites about how this part isn't exact and could require you to extend 1 or 2 of the wire harnesses since a few of the solenoids are rotated from the original part (of course the slack in the wire is tight so no extra give is allowed.. thanks Maytag!). I gave it a shot and I did need to extend 2 of them. Wasn't a big deal for me since I'm a decent at soldering and already had low voltage wire laying around. Could have used wire clips to extend too but since I had the solder on hand I just did it that way. Regardless - part works perfectly - no more drippy dip into my washer tub anymore! Definitely recommend this (outstanding value - thanks McComb!) but just note if this isn't the exact part number to be prepared to extend at least one of the wire harnesses.
The part works fine however, I had to extend the wire harness because one of the connectors on the new part is facing further away and the harness wire did not reach. No big deal, but I am glad I have the right gauge of wire to extend it.
valve worked as it should but solenoids are turned slightly different than OEM valve. Had to extend some wires to make plugs reach.
The inlet valve assembly had been jostled in shipment inside the manufacturers box. The box was all cut up inside where the solenoid tab was striking it and one of the tabs had gotten bent. I carefully straightened it and it worked properly.
