PLF260HA L260-50 Limit Thermostat Flush Mount For Furnace Unit Heaters

Packard Automatic Small Flush Mount SPST Limit Thermostat Part Number PLF260HA.

L260-50*F.

Automatic reset.

Cut out temperature 260*F.

Cut in temperature 210*F.

Terminals are horizontal and 1/4" width diameter.

Mounting holes are 1" apart center to center.

Fits on gas fired furnaces, unit heater, and rooftop units.

Common OEM Cross-References

If your furnace, unit heater, or rooftop unit uses any of the following original part numbers:

• Supco: SLF260HA is a direct match
• Mars / JDL: 39260
• White-Rodgers: 3F01-260
• Todd / Therm-O-Disc: 36T11 (with a 260°F cutout specification)

Compatibility by Specifications

You can install this part on any gas-fired furnace, unit heater, garage heater, or HVAC system where the faulty factory switch matches these parameters:

1. The Temperature Limit: The factory switch must be stamped with a 260°F limit (sometimes written as L260). Never use a higher or lower temperature switch than what your unit's data plate requires, as it is a critical fire safety component.
2. Mounting: It features a small, flush-mount design (often used as an automatic rollout switch or tight-clearance limit).
3. Terminals: It uses 1/4" horizontal quick-connect male spade terminals.

Common brands that utilize 260°F limit switches in their equipment lines include Goodman, Carrier, Bryant, Rheem, Ruud, York, and Modine.

Before purchasing, verify this part will fit with your model number